It is permissible to have multiple AP with the same SSID. This is standard practice in a multi-AP environment. You just need to make sure they are on different channels. You can leave them broadcasting if they are both the exact same SSID, or you can disable the broadcast on the second and follow what Mike said.
Should an access point have the same SSID?
The APs should be on different channels to avoid interference. If there are other APs in the building, try to minimize co-channel interference by selecting unused channels (if possible). You can use the same SSID, which will make roaming a little easier.
What happens if two WIFI networks have the same SSID?
Two identically named SSIDs with the same password will allow your device to connect to either, without having to add any extra networks on your devices. If both routers are broadcasting from the same location, the expected behaviour will vary depending on device.
Should multiple access points be on the same channel?
When APs have overlapping coverage they should be set to different non-overlapping channels. This prevents the APs from causing an increase in channel utilization or interfering with each other. The goal of using different non-overlapping channels is to avoid the affects caused by channel utilization and interference.
Can you have too many WiFi access points?
When you have APs in overlapping channels, it causes interference. If channels overlap and there are too many APs this will definitely cause poor performance. The purpose of a WiFi site survey is to determine the best and most optimal AP placement for the best coverage without channel overlap.
Can you have two wireless routers in one house on different networks?
Yes, it is possible to use two (or even more than two) routers on the same home network. A second router provides more open Ethernet ports so that additional computers can join the network.
Why is there 2 of the same WIFI?
The idea is to spread out your devices over the two bands so that there’s less competition for the same channels. Separating your personal and Internet of Things (IoT) devices can also help your WiFi security. By splitting your devices between 2.4GHz and 5GHz, you can maximize your network’s performance.
Can I use both 2.4 and 5ghz at the same time?
Simultaneous dual-band routers are capable of receiving and transmitting on both 2.4 GHz and 5 GHz frequencies at the same time. This provides two independent and dedicated networks which allows more flexibility and bandwidth.
How do I make two routers have the same SSID?
Setting Up Wireless Routers With the Same SSID
- Open the administration page for your primary router.
- Log in with your username and password.
- Locate the LAN settings and change the range of available IP addresses to remove the first one.
- Save the new settings and power off your primary router.
Can I set a different SSID for each AP in WDS?
[Optional] Set each AP to a different SSID. WDS APs know each other by MAC address and could care less what their SSID is set to. On the other hand, wireless clients associate by SSID. Technically, each AP in a WDS network is part of the same Extended Service Set (ESS) and should therefore have the same SSID.
What is the difference between WDS bridge and AP?
WDS Bridge usually requires dedicated hardware at each remote location operating on independent channels, though some APs allow for one radio (typically the 5 GHz) to be in WDS bridge mode and the other radio (typically the 2.4 GHz) to be in AP mode to provide Wi-Fi service client devices.
What is WDS bridging on TP-Link dual band routers(green UI)?
How to Configure WDS Bridging on TP-Link Dual Band Routers (green UI)? A Wireless Distribution System (WDS) is a system that enables the wireless interconnection of access points in a wireless network.
What is a wireless distribution system (WDS)?
This Article Applies to: A Wireless Distribution System (WDS) is a system that enables the wireless interconnection of access points in a wireless network. It allows a router’s wireless network to be expanded using multiple access points without the need for a wire to connect them, as is traditionally required.
