Repairs needed to fix the P0339 code vary depending on the underlying cause, but can include the following:
- Repairing or replacing damaged wiring.
- Repairing loose connections.
- Repairing oil leaks responsible for degradation of wiring.
- Replacing a failed crankshaft position sensor.
- Replacing broken reluctor rings.
How do you fix a crankshaft position sensor on a circuit malfunction?
To fix the engine from this error code, use a scan tool and inspect whether the engine is cranking or running. There should be an RPM signal. If there is no RPM reading, then conduct a visual inspection on both the crank sensor and connector, and search for signs of damage. Repair as needed.
Where is the crankshaft position sensor located?
The sensor is at either the front or the back of the crankshaft, so it’s usually located either on the transmission bellhousing or behind the crankshaft pulley. There should be a small air gap, usually about a millimeter or two, between the sensor and the reluctor.
How much does it cost to fix a crankshaft sensor?
The replacement cost of the crankshaft position sensor is anywhere from $120 to $300. The cost of the part itself will be around $75 to $120. The cost of the labor will be anywhere from $45 to $180.
Is it bad to drive with a bad crankshaft sensor?
Once the position sensor becomes compromised or if you have symptoms of a problematic crankshaft that you can’t ignore, do not drive your vehicle. If the problems are more severe, driving can cause substantial engine damage that could cost you a lot more to repair.
How much is a BMW crankshaft sensor?
BMW 328i Crankshaft Position Sensor Replacement Cost Estimate. Labor costs are estimated between $138 and $174 while parts are priced between $123 and $135.
Can you drive with bad crankshaft sensor?
How much does it cost to replace crankshaft position sensor?
The average cost for a Crankshaft Position Sensor Replacement is between $178 and $226 but can vary from car to car.
What causes the crankshaft position sensor to go bad?
There are a few things that can cause the crankshaft position sensor to fail, including damage, debris and faulty circuitry. Even for modern electronics, the engine is a violent and destructive environment. Though built for this, most sensors eventually succumb to the ever-present heat and vibrations of the engine.
What does the p0339 code on a crankshaft position sensor mean?
If crankshaft position sensor input voltage is too low over a set period of time, a P0339 code will be stored and a MIL may be illuminated. Other crankshaft position sensor B trouble codes include P0335, P0336, P0337, and P0338.
What causes the p0339 code on a Honda Accord?
A number of potential causes may lead to the P0339 code being set in the car’s computer, including the following: Damaged crankshaft position sensor. Damage to the sensor’s connectors. Damage to the sensor’s wiring harness. Broken reluctor rings or missing teeth. Damage caused by a broken timing belt wrapping around the sensor system.
How long is the warranty on a p0339 code?
All our repairs are backed by our 12-month / 12,000-mile warranty. The P0339 code indicates that the car’s computer has detected a voltage signal from the crankshaft position sensor that exceeds the maximum variation set by the automaker.
What should I do if my CKP sensor is p0339?
If the P0339 is reset, locate a system wiring diagram from your vehicle information source and check for voltage at the CKP sensor. A five-volt reference is normally used for CKP sensor operation but check manufacturer’s specifications for the vehicle in question. One or more output circuits and a ground signal will also be present.
