Relearn procedure: Insert ignition key and turn to the ON position. Do not attempt to start the engine. Leave the key in the ON position for approximately 11 minutes. The security light will be on or flashing for the 11-minute period.
How do you reset the security system on a 2001 Chevy Impala?
Open the trunk or any door of the Impala. Switch the lock to the “lock” position. Remove the key from the ignition. The light on the radio display will flash quickly; this signals that the system is resetting.
How do I get my Impala out of theft mode?
Make sure the security light is flashing. After 10 minutes the security light will stop flashing and either turn off or stay on steadily. Put the key in the On position. Wait ten minutes until the security light on the dash stops flashing.
How do you reset a Chevy key?
On your Chevy key fob, press and hold the “Unlock” and “Lock” buttons simultaneously until you hear the door locks engage and disengage again, indicating that you have successfully programmed your key fob. Re-insert the newly programmed key into the ignition in the “On” position to end the programming sequence.
Can you use a used ignition switch?
Yes, you can. The ignition switch is separate from the EWS system, so replacing the switch will still allow you to use the current keys you already have. Only if you have to replace a faulty key or EWS module will you have to possibly order all new keys.
How do you reprogram an ignition switch?
How to Program an Ignition Switch
- Enter your car with your cut ignition key and insert the key into the ignition switch.
- Turn the key to the “On” position and leave it in that position for 10 minutes and 30 seconds.
- Turn the car back to the “Off” position within 45 seconds of the 10:30 elapsing.
Why is my Impala not starting?
While there are a variety of reasons your Chevrolet Impala won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
How do you turn off the security system on a 2001 Chevy Impala?
Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start. Look at the dashboard and locate the theft system light. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.
