Step 1: Quickly triple tap and hold the Test or Light button on the Sensor. DO NOT release after third tap. Step 2: Keep the button pressed after the third tap for a few seconds until the dome LED begins to flash slowly (approximately once per second). The Sensor has now been returned to Factory Default Settings.
Why does my sensor light not turn off?
If your outdoor security light won’t turn off, it’s most likely because of one of these problems: The sensitivity settings are too high. The duration settings are too high. It’s stuck in auto mode.
What is a Lutron lighting system?
Daylight Harvesting. By using shades in conjunction with dimmers, Lutron systems can create the perfect balance between the two sources of light to save energy and create an inviting environment. Dimming modifies the quantity of electric lights, which in turn are complimented by the proper shade fabric and control that filters daylight.
What is TRIAC dimming?
TRIAC dimming controls act as a high-speed switch and are used to control the amount of electrical energy passing to a bulb. A ‘trigger’ dictates what point the device starts to conduct the electricity, essentially “chopping up” the voltage waveform, stopping the voltage from being supplied at full load.
What is dimmer control?
Dimmer switches are devices that allow the amount of light a lamp is emitting to be controlled. Whereas a lamp or lighting fixture without a dimmer can only be turned on or off, a light switch with a dimmer can be controlled so the light is set to a desired level of illumination. Grid List.
What is a dimmer light bulb?
All incandescent light bulbs can be dimmed because the bulb is made of filament not chip on board (COB) technology. With an incandescent bulb, a dimmer works by lowering or raising the voltage to demand the amount of light output you desire; it is a simple task since there aren’t any electronic components.
