Charging your battery
- Connect your Battery’s T-Connector to the T-connector-to-Banana-Plug Cable.
- Connect the Balance Connector to the 3 Cell port in the LiPo Charger.
- Plug your 12v 5A power supply into the Balance Charger using a 2.1/5.5mm Jack to 2.5/5.5mm Plug Adapter.
- Press the Batt.
- Press the Inc.
How do you use the iMAX b6ac charger?
iMAX B6 Chargers
- Plug in the mains adapter and plug it into the battery charger.
- Connect the charging lead from the charger to the battery.
- Connect the monitoring lead from the battery to the charger.
- Place the battery in the charging bag.
- Configure the charger using the menu system as follows.
What is storage voltage for Lipo?
approximately 3.8 volts
Storage Voltage When you get a new lipo battery it will already come partially charged. This partial charge is called the Storage Voltage. Storage voltage is where each cell is charged to approximately 3.8 volts.
How does a lipo balance charger work?
This charger assures that the cells are ‘balanced’ at all times by charging them in parallel. When the cells are connected in parallel, any difference in charge level is equalized and they appear as a single cell to the charger. At all times during the charge, the cells are at equal charge levels.
How do you charge a Nicad battery?
The cheapest way to charge a nickel cadmium battery is to charge at C/10 (10% of the rated capacity per hour) for 16 hours.. So a 100 mAH battery would be charged at 10 mA for 16 hours. This method does not require an end-of-charge sensor and ensures a full charge.
How do you know if LiPo is fully charged?
LiPo batteries are fully charged when they reach 4.2v/cell, and their minimum safe charge, as we will discuss in detail later, is 3.0v/cell. 3.7v is pretty much in the middle, and that is the nominal charge of the cell.
