Push down on the entire cooler so that all 4 pins are through the motherboard. When you push down on the top black pins, it expands the white plastic pins to fix the cooler in place. The trick to getting it on is to push down on a DIAGONAL pair of pins at the same time. Then the other pair.
Can you reseat CPU without reapplying thermal paste?
It might be tempting to spread the thermal paste onto the CPU yourself. If you absolutely need to reuse an application — while waiting for replacement paste, for example — you can, but keep in mind this is a short-term solution, and that we recommend a proper reapplication before long-term use of your CPU cooler.
Can you reseat CPU fan?
To reset the processor fan push pins, remove the fan and reinstall it as shown below. Remove the fan connector from the fan header. Turn the push pins with a flat bladed screwdriver counterclockwise 90 degrees to release them. Reinsert the fan and find the push pins.
What does reseating a CPU do?
Reseated the CPU and everything was fine. Question: what is it about reseating the CPU that fixes problems? What I mean is, CPU goes in fine the first time with everything the way it should be. When you reseat the CPU you just lift it out and put it back in the same way.
How do you adjust a heatsink?
Blast compressed air directly on the heat sink. It only takes a few good squirts to clean a blockage. If it’s persistent, allow a few seconds before repeating. Carefully wipe off any residual thermal paste.
Can you reseat CPU?
You should remove the old thermal grease from the processor and apply a new layer after reinstalling the CPU. Apply a small dollop of thermal grease to the top of the processor and then use the brush or paddle packaged with the product to spread the grease in a thin layer on the surface of the CPU.
How do you reapply thermal paste Reddit?
Clean it, re apply it. Use isopropyl alcohol, you can find it at Cvs either 70% or 91% both will work. A lot of people will cringe, but my go-to cleaning agent for thermal paste is brake cleaner. Just spray it on a microfiber cloth and clean up the paste.
