Some drop spindles allow you to use a lot of your current stock components as well, so you can use stock coils, stock shocks, and keep your steering geometry the same. Just spindles can drop you two inches, but if you elect to get aftermarket springs as well it’s possible to go down as low as 5 inches.
How can I lower my truck cheap?
Drop it Like it’s Hot: 8 Ways to Lower a Truck
- Lowering Springs. Back in the day, customizers would cut or heat up springs to lower vehicles.
- Drop Spindles.
- Torsion Bars.
- Suspension Arms.
- Leaf Springs and Shackles.
- Rear Flip Kits.
- Coil-overs.
- Full Chassis Replacement.
What does C10 stand for on a Chevy truck?
The “C” in C10 indicates that the truck is a two-wheel drive model. The Chevrolet C/K series consisted of two-wheel drive trucks, labeled with a “C”, and four-wheel drive trucks, designated by the letter “K.” The C10 was the half-ton, two-wheel-drive model within the C/K line of trucks.
What does the 10 stand for in C10?
The C10 model was used by Chevrolet in the years 1960-1987 to define the 2WD drivetrain and ½ ton chassis of every truck they produced. The “C” marking the truck as 2-wheel drive, and the “10” marking it as a half-ton.
How much does a flip kit lower a truck?
A flip kit is designed to move the rear axle of your truck from being underneath the leaf spring pack to being on top of the leaf spring pack. This will generally give about six inches of lowering to the back of your truck.
Is a C10 a Cheyenne?
For 1971, the Cheyenne trim package was introduced as the Chevy equivalent to the GMC Sierra. The Cheyenne Super, however, was the top-of-the-line C10 pickup truck from that era.
Is a C10 4×4?
While the C represents the two-wheel drive trucks, the K designates the four-wheel drive trucks. That being said, the C10 was the half-ton, two-wheel drive truck, and the K10 was the half-ton, four-wheel drive truck.
What is a flip kit?
A flip kit is designed to move the rear axle of your truck from being underneath the leaf spring pack to being on top of the leaf spring pack. This will generally give about six inches of lowering to the back of your truck. That measurement will be within 1/4 inch of the amount of lowering you will get with a flip kit.
