450 hp
Because of this odd power flow, Lentech’s Len Bertrand tells us a stock AOD can handle 450 hp, at best, and will always be hard on 3/OD clutch packs.
What transmission is in my 1965 Mustang?
The 1965 Mustang used a Ford 2.77 Toploader 3-speed in the 170 and 200 Six engines and used the Ford 3.03 Toploader behind the V8 equipped cars. The Borg-Warner T10 or Ford T & C Toploader were used in all 4-speed applications. The tried and true Ford Cruise-O-Matic was used in all automatic transmission applications.
Is the AOD a good transmission?
The Ford AOD transmission was evident in cars like the Mustangs, Fairmont, and LTDs around 1980 and 1993, and it was quite unique even though not in a really good way. The Ford AOD transmission shifting problem, therefore, gave it its unreliable performance reputation.
What did the AOD transmission come in?
The AOD (automatic overdrive) is a four-speed automatic transmission, with the 4th gear as overdrive. Introduced in 1980, it was Ford’s first four-speed automatic overdrive transmission….Ford AOD transmission.
| AOD | |
|---|---|
| Overview | |
| Production | 1980–2014 |
| Body and chassis | |
| Class | 4-speed longitudinal automatic transmission |
Are all AOD transmissions the same?
The AODE and 4R70W transmissions were an all-new AOD case designed for electronic interaction with engine controls. The AODE and 4R70W are essentially the same AOD-based transmission. This is a 1997 4R70W with a speedometer drive and output shaft speed sensor.
How much does a Ford AOD transmission weigh?
The AOD weighs 150 pounds, about 40 lbs. heavier than a C-4 or C-6 transmission. Shift ratios are: 1st, 2.40:1; 2nd, 1.47:1; 3rd, 1.00:1; OD, 0.67:1; Reverse, 2.00:1. These ratios are very close to the 2.46:1 ratio used in the three-speed C-4 and C-6 transmissions, but with the added benefit of an overdrive.
Did 1965 Mustang have automatic transmission?
There was only one automatic transmission, which makes identifying it very easy. The only Mustangs that could not be equipped with an automatic transmission were ones with the HiPo V8 engine. The 1965 Mustang’s manual transmissions get a little trickier.
How much HP does a 289 V8 have?
Ford’s 289 High Performance V-8 introduced in 1963 and first available as a Mustang option in 1964 is a high-revving, peppy Ford V-8 with a factory rating of 271 horsepower.
Does a Ford AOD need a computer?
The Ford AOD does not need a computer to function properly either. Ford later used this transmission as a basis for their newer overdrive versions, the electronic-overdrive AOD-E, which was used beginning in 1993 and in the 4R70W which was used on 1999 and up production cars and trucks.
What transmission goes with a 302?
For years, the Ford C-4 automatic was a reliable three-speed automatic transmission for many Ford products, and is fine for most 289, 302 or 351 engines that have received modest modifications.
How can you tell the difference between AODE and AOD?
Look for the electronic cable and electrical plug. AODE and 4R70W transmissions have a plug on the driver’s-side rear of the transmission housing. This is where the electronic control cable plugs into the unit and is what differentiates the older AOD transmission from AODE and 4R70W units.
Does Ford AOD need computer?
How much does it cost to convert a 1965 Mustang to AOD?
Select an option… No Level 1 ($ 1699.00) Level 2 ($ 2399.00) Level 3 ($ 2974.00) Level 4 ($ 2829.00) C4 to AOD Swap Kit, 1965 to 1973 Classic Mustangs / AOD Conversion Kit / AOD TV Cable Adjustment. Add Transmission if Needed quantity #K65M.
What is included in the AOD to early Mustangs?
You get the AOD to early Mustang crossmember, Lokar throttle valve cable, correct speedometer driven gear, correct flywheel, dip stick, shift lever kit, carburetor adapter for Holley or Edelbrock, transmission mount, block plate, inspection plate and four torque converter nuts. You can add to or remove from this kit as needed.
What kind of transmission does a Mustang have with a 289?
This Kit makes it easy to convert your 65 or 66 Mustang with a 289 302 or 351W engine from a C4 or C6 transmission to an AOD automatic overdrive transmission. See Below for More information. Flexplate, 164 Tooth, 28 Ounce.
What size torque converter do I need for a 1996 Mustang?
TORQUE CONVERTER HEIGHT DIMENSION NEEDS TO BE 0.850 FOR FLEXPLATE TO FIT PROPERLY. RECOMMENDED 1989-1993 MUSTANG AOD TV CABLE TRANS OR 1994-1995 FORD MUSTANG AODE TRANSMISSION AND NOT FROM A FORD TRUCK. IF USING 1996 AND UP AOD-E “CAR” TRANSMISSION, THIS KIT WILL WORK BUT THE TRANS WILL NOT REQUIRE THE LOKAR KICK DOWN CABLE.
