5.0 out of 5 stars A great analog scanner with a wide frequency range. It is not digital.
Is the Radio Shack Pro 164 a digital scanner?
The pro 164 is a analog scanner not digital so please check with your city to see if this can be use there before you buy.
How do you reset the scanner on a HP Pro 163?
To Initialize the scanner, turn off the scanner then turn it back on. Press 0 when the welcome screen appears. ‘Please select factory tests. Exit if no key is pressed’ will briefly appear.
How do you program a Radio Shack triple trunking scanner?
- Press PROG, then press TRUNK.
- Press FUNC, then use an UP or DOWN ARROW to select a bank.
- Repeatedly press MODE to select a trunking mode (Motorola, EDACS,LTR).
- Press PROG.
- Enter the first control channel freq.
- Repeatedly press MODE to select a trunking mode (Motorola, EDACS, LTR).
How do I program my Radio Shack 1000 channel scanner?
Press the “Program” button, then “Limit.” “LO” will appear on the screen. Enter the low frequency where you want to begin searching. Press the “WX/E” button and “HI” will appear on the screen. Enter the highest frequency you want to search to and press “WX/E” again.
How do I reset my Radio Shack Pro 164 scanner?
To initialize the scanner, turn the scanner off, turn it on again, when the welcome message comes on the display, press 0, then press 1, then ENT. “Initializing please stand by” appears for about 5 seconds. When the initialization is complete, the scanner will show Bank 0, Ch 00.
How do I program my Radio Shack desktop scanner?
How do you program a realistic police scanner?
How to Program a Realistic Scanner
- Install fully charged batteries.
- Press the button marked “Manual” on the scanner keypad.
- Use the keypad to enter the channel number you want to program and press “Manual” again.
- Press the “./Clear” button to clear the screen and prepare for the new frequency.
Can the pro-163 be used as a desktop or mobile unit?
The PRO-163 triple trunking scanner can be used as a desktop or mobile unit. Would you like to tell us about a lower price? Brief content visible, double tap to read full content.
How do I upgrade the firmware on my pro-163?
Please see the Connecting scanners via USB article for USB cables to connect your PC to the scanner You can verify the version of firmware currently active in the Pro-163 by pressing the 3 key during the “Welcome” screen. Firmware upgrades can be installed by downloading and running an upgrade program.
Where was the GRE pro-163 made?
The Pro-163 was manufactured by GRE in China. The Pro-163 is very similar to the GRECOM PSR-400 and Radio Shack Pro-164 and uses the same software and cables. Note: This radio can not be computer controlled. Can be updated to support Rebanding?
How much does it cost to program a scanner?
Case in point: every modern scanner should be programmed via a PC. They charge about $30 for the programming cable. Uniden includes a programming cable. Uniden also writes their own programming software, albeit crappy and pricey. RS didn’t even bother, they rely on you to find and purchase third party software.
