What I told him is that he’d need hinges, a gate latch, a gate stop, and a cane bolt (also called a drop bolt). The choice of hardware should be guided by style, material (choosing an appropriate material for your location), and budget. Double gates have a ‘functional’ gate and and a ‘fixed’ gate.
How do you open a double gate from both sides?
Thumb latches are typically for in-swinging gates and are double sided, meaning they can open and close from either side of the gate. Mounted on the street side of the gate typically is a decorative plate with a thumb depressor. Push the thumb and the latch-arm on the inside lifts, allowing the gate to open.
Should a double gate swing in or out?
Swing Inward or Outward? Your gate should always swing inward.
Can Gates open both ways?
I find the frequency of this question peculiar since the need to have gates open outwards is rare, but simply the answer is yes. Automated swinging driveway gates can open outwards if necessary. Traditionally, gates swing inwards, which is in the direction visitors enter your property.
How do you keep a double gate closed?
The ease of locking a double gate can range from easy to fairly complicated. Simple solutions include single-sided locks like a slide bolt that would slide from one gate to the other. Slide bolts and surface bolts are available in many sizes and materials, so you can find what you like.
How do you level double gates?
Place a level on the top cross-member of the gate and raise the lever until the gate is level, then raise the lever until the gate is 1 inch higher than the level position. Slide a large rock or other solid object under the high end of the lever to hold the gate in position.
How much gap do you need between double gates?
The gates need to be the right size for the opening. Allow 1-inch clearance on the outside edges to enable most hinges to operate properly. Allow at least 1/2 inch between the gates as they meet in the middle.
How wide should a double fence gate be?
On widths of 6′ or more, use a double swing gate. Your front house door is no bigger than 36″ so a minimum of 36″ wide gates should be used. Your appliance will not fit through the gate that you want in the house. A driveway should have 12′ minimum clearance through the gate.
How to build a double gate?
Measure for the gates. Measure the width of the opening between the fence posts where the gates are to go.
How do you replace a fence gate?
1. Unscrew the gates from the fence posts and remove the old hinges. 2. Set the gate across two sawhorses. 3. Steal a picket from an inconspicuous area of the fence and use it to replace broken gate picket.
What size are chain link fence gates?
Vinyl posts normally 4” x 4”, 5” x 5” and 6” x 6” and length vary from 72” to 102”. Line posts for chain link fences made of 16 gauge galvanized metal typically 1 5/8” or 2” in diameter.
What is a double drive gate?
A double drive swing gate uses a drop rod assembly that is installed between the two leaves and pins the gate leaves to the ground. This is not as secure as a single swing gate that uses a latch post set into a concrete footing.
