Slotted Deflection Track is a CFS top track manufactured to prevent cracking of finishes applied to interior partition framing resulting from deflection of structure above. This is achieved by fastening studs to top track through provided slots, allowing fastener vertical movement of up to 1 ½”.
How does a deflection track work?
Slotted deflection track relies on the metal studs being fastened to the track through slotted holes in the track legs. The studs must be fastened so they can slide within the track. Over tightening the fasteners will prohibit movement.
What is the purpose of deflection track?
Protect Your Walls While Cutting Cost. Steeler Deflection Track is an economical alternative for ceiling connections of non-load bearing walls. Our deflection track is engineered to allow for ceilings to deflect under loading without affecting the wall underneath.
What is deflection head track?
The Deflection Head Track allows a vertical movement from the ceiling/ roof. This vertical deflection prevents loads from being transferred to the studs.
What is the purpose of the deflection clip when installing exterior steel studs?
ClarkDietrich FastClip™ Slide Clip 68mils (14ga) deflection clips are used to attach exterior curtain-wall studs to the building structure and provide for vertical building movement independent of the cold-formed steel framing.
What is slotted slip track?
Mill Steel Framing Slotted Slip Track is manufactured to provide head of wall integrity during vertical building movement. Slotted track is positively secured at the head of the wall and will absorb up to 1” of vertical deflection. …
What is metal stud deflection?
Deflection heads are used within GypWall metal stud/ShaftWall partitions when needing to allow for movement (up, down or both) within the structure at the head of a partition. This movement (or deflection) is created by live and dead loads on the floor or roof above.
What is stud deflection?
The deflection joint is the distance between the top of the stud framing to the underside of the substrate above (floor or roof member), as defined by the project’s architect or structural engineer. The top of the gypsum wall board to the underside of the substrate should also equal this distance.
What is slotted track?
Cold-Formed Steel Slotted Track is designed for use at the head of wall to protect the integrity of walls during building movements by absorbing vertical movement caused by expansion and contraction, wind forces and seismic events.
What is a deflection clip?
What is a vertical deflection clip?
This vertical deflection clip is used to connect exterior cold-formed steel curtain wall studs to the slab, bypassing the primary structure , while allowing for vertical deflection of the structure up to 2” (1” up & 1” down).
What is a slip track?
A slip track is a channel section (typically the top track) of a non-load bearing or curtain wall framing assembly that is fastened to the primary structure, but left unconnected to the vertical stud members. Stud horizontal reactions are resisted by the slip track flange.
How to frame wall with metal studs?
Metal Studs vs Wood.
What is the thickness of a metal stud?
The gauge, or thickness, of nonstructural metal studs is less than the gauge of structural metal studs. The widths of nonstructural studs’ webs are comparable to their structural counterparts: 3-½ inches, 6 inches, 8 inches and 10 inches. The flanges of nonstructural metal studs are 1-1/4 inches.
What is a metal wall stud?
Metal studs are used extensively in the commercial building industry, but they offer some distinct benefits for residential construction as well. Typically limited to the framing of nonstructural, or partition, walls, metal studs don’t rot or warp, and they’re impervious to insect damage.
What is the spacing of metal studs?
Locate metal studs with an ordinary stud finder, and then locate the center of the stud. Common stud spacing for metal studs should be 12, 16 or 24 inches on center.
