Craftsman LT1000 – the older ones from 2000-2005 and some from 2006-2007 are very sturdy and have the wide body now reserved for higher-end YTs (“Yard Tractors”), mostly heavy-duty decks, solid controls, and basically last forever with either a Briggs and Stratton single or twin cylinder or a Kohler single cylinder.
How many horsepower is a craftsman LT1000?
15.5 hp
Craftsman 28701 15.5 hp 38 in. Deck, LT 1000 Lawn Tractor.
What is the life expectancy of a Craftsman riding lawn mower?
Brands like Husqvarna, John Deere, Toro, and Craftsman riding lawnmowers, have an average life expectancy that is really high. With proper care and maintenance, this can be up to 20 years.
How wide is a craftsman LT1000 riding mower?
The mowing deck has a cutting width of 42 inches (it’s total width is a good bit higher than this due to the plastic discharge flap on the side). Inside the deck are 2 blades working together to give a nice smooth, even cut to your lawn.
What kind of spark plug do I need for a craftsman LT1000?
2 Champion Spark Plug RC12YC For Craftsman LT1000 YT4000 YT3000 John Deere LA135 | eBay.
What size deck belt does a craftsman LT1000 take?
There are two belts that might be needed on that model. One is a v-belt for the mower, which is part number 144959. That belt measures 1/2 wide by 11/32 thick by 95.25 long. The other belt is a drive v-belt, part number 401603.
Is 300 hours a lot for a riding mower?
A: “Most residential lawn tractors are made to last 250 to 300 hours, so you really need to know how many hours the tractor was used,” says Peter Sawchuk, who directs Consumer Reports lawn mower and tractor tests. “There’s no point spending $500 for a machine that’s only going to last a year.”
Is 400 hours a lot for a lawn tractor?
As a rough rule of thumb, a single-cylinder mower with 500-750 hours would be considered a high miler, but that’s not to say it’s all worn out. A well-maintained mower will go on and on, as said earlier, my own ride-on mower has about 1000 hours and still pulls its weight around here.
Where is the model number on a Craftsman lawn tractor?
The model number of your Craftsman riding lawn mower is located under the operator seat. This label also includes the serial number.
How much oil does a craftsman LT1000 take?
Generally speaking you will need to use the oil fill cap/dipstick to gauge the oil level. It could take up to 48 ounces of oil if you did NOT replace the filter or up to 56 ounces if you DID replace the oil filter.
Does my Craftsman riding mower have a fuel pump?
If the fuel tank is under the operator seat, there will be a fuel pump. Most 19.5 Briggs and Stratton engines on the Craftsman tractors are under the hood, and therefore will not have a fuel pump.
How do you start a craftsman riding lawn mower?
Insert the riding mower ignition key into the ignition switch and turn the key to the right. Allow the starter to crank the engine for 15 seconds. If the motor does not start, turn the key off and wait 10 seconds. Turn the key back to start and crank the starter for 15 seconds.
Who makes the new Craftsman riding mowers?
Craftsman is one of the market leaders in mower and tractor sales. Many models in the Craftsman line are made by Husqvarna; others are made by MTD. Craftsman lawn tractors run the price spectrum from gear-drive models priced at about $1,000 to fully featured, hydrostatic-drive units that cost more than $2,000.
What is the model number for Craftsman lt1000?
The Craftsman LT1000 garden tractor lawn mower is often known by it’s serial number, the Craftsman 27639. Both refer to the same tractor mower. The engine powering the LT 1000 is an Intek model from Briggs and Stratton . This is a two stroke, 1 cylinder model that pumps out 18 hp.
How much does a craftsman riding mower weigh?
How much does a riding lawn mower weigh? Brand Model # Weight Craftsman 27343 525 pounds Craftsman ProSeries 27038 580 pounds Poulan Pro 960420204 428 pounds Poulan Pro 960460077 437 pounds
