The neutral safety switch on a 2005 Jeep Liberty or gear range sensor is located on the left side of the transmission. The neutral safety switch is a safety device that only allows You to start Your engine when the automatic transmission is in either Park or Neutral.
What are the symptoms of a failing neutral safety switch?
Symptoms of a Bad or Failing Neutral Safety Switch
- Engine will not crank in park but cranks in neutral.
- Engine will not crank in neutral but cranks in park.
- Engine does not crank at all, regardless of the transmission gear.
- Engine cranks in any gear.
Where is the park neutral switch located?
First Step: Locate the Neutral Safety Switch It should look like a cigarette lighter, and typically, it is located by the shift mechanism. If you have a column switch car, you should look near the gear shifter. The neutral safety switch should be threaded onto the side of the transmission.
How do you put a 2002 Jeep Liberty in 4 wheel drive?
Grasp the transfer case shifter on your Jeep and shift from two-wheel drive to four-wheel drive high range by pulling straight back on the shifter from “2H” to “4H.” This shift can be made at any speed less than 55 miles per hour, without stopping.
Can you drive a car with a bad neutral safety switch?
Yes, a faulty neutral safety switch can not only cause frustrating shift issues, but it could also lead to more serious mechanical difficulties or play a part in an accident. The neutral safety switch is part of the transmission and helps keep the car from rolling backward when you’re parked.
How much does it cost to replace a neutral safety switch?
Replacement Cost Having the neutral safety switch replaced can cost anywhere between $100 and up to around $350 for both parts and labor, depending on the make and model of your vehicle, as well as the type of specialist working on the system.
How do you test a neutral park switch?
Move the shifter to the “Park” position so that your vehicle doesn’t move, and try to start. If the engine didn’t crank, then push down the brake and try to start in “Neutral.” This way you are bypassing the “Park” position in the switch. If the engine starts in “Neutral,” the switch is bad.
How do you switch a Jeep Liberty to 4 wheel drive?
