It’s an error code when the thermometer is not positioned correctly in the ear.
How do I change my Braun Thermoscan thermometer from Celsius to Fahrenheit?
Press and hold down the «start» button. After about 8 seconds the display will show this sequence: «°C» / «°F» /… Release the «start» button when «°F» is shown. There will be a short beep to confirm the new setting, the thermometer then turns off automatically.
How do I change Braun Thermoscan 7 from Fahrenheit to Celsius?
You will turn between Celsius and Fahrenheit to and from. Click the Start button for 8 seconds before the two configurations display. After seeing °F, click the Start. A quick beep would check the current setting, and the thermometer then shuts off completely.
How do you calibrate a Braun Thermoscan thermometer?
- Remove the PRO 6000 Thermometer from the 9600 Plus Calibration Tester and read the temperature in the thermometer’s display. If the temperatures are within ±0.2 °C, the thermometer is within calibration.
- Apply a new probe cover.
- Repeated measurements in short sequence may cause higher readings.
How do I fix the POS error on my Braun thermometer?
System Error – Wait 1 minute until the thermometer turns off automatically, then turn on again. If error persists reset the thermometer by removing the batteries and putting them back in. If error still persists contact your Welch Allyn representative. Insert new batteries.
How do I change my Temple Touch thermometer to Fahrenheit?
The default temperature scale is fahrenheit (°F). To change the scale to °C, or back to °F: 1. While off, press and hold the multifunction button for about five seconds. The hourglass icon will display, then the °F or °C will change.
What does PO5 mean on a Braun thermometer?
What does po5 mean on Braun thermometer? The code is POS which means “If the probe has not been constantly placed in a stable position in the ear canal, a sequence of short beeps will sound, the exac temp light will go out and the display will show a error message POS=position error.”
Why does my Braun Thermoscan say Pos?
This is in the manual that comes with the thermoscan. why does my Braun thermometer say Pos? The POS error means that the thermometer probe was not positioned securely in the ear, and an accurate measurement was not possible. Our trouble shooting tip for this error is to take care that the positioning of the probe is correct and remains stable.
How do I change the temperature scale on my Braun Thermoscan?
Your Braun ThermoScan is shipped with the Fahrenheit temperature scale activated. If you wish to switch to Celsius «°C», proceed as follows: Make sure the thermometer is turned off. Press and hold down the «I/O» button. After about 3 seconds the display will show this sequence: «°F» / «SET» / «°C» / «SET»…
Can the Braun Thermoscan thermometer be used with other probe covers?
• This thermometer must only be used with genuine Braun ThermoScan probe covers (PC 800). • To avoid inaccurate measurements, always attach a new, clean probe cover for each temperature measurement.
