An air pump that loses power or gets very loud may have a bad rubber diaphragm. These parts are located inside the pump. Just remove the screws on the bottom of the pump to open it up. If you cannot do this, make sure the pump is higher than the aquarium.
Why do air pumps stop working?
The most likely cause is that the air pipes of the filter are disconnected or blocked or the air pump has broken down (See Q1). Once the pipes are cleared or reconnected or the pump has been repaired or replaced – the filter will work again and the tank will clear.
Why did my air compressor stop working?
An air compressor problem could stem from one of many issues, such as an air leak, an oil leak or a broken part. In some cases, you might have insufficient pressurization or air flow. In other cases, the compressor might fail to start up or stop running as prompted.
How does an electromagnetic air pump work?
The activated electro-magnet attracts the piston against the return spring, while air is taken into the cylinder through the opened inlet valve. When the electro-magnet is deactivated, the return spring pushes the piston back, and the compressed air is brought out of the cylinder through the now open outlet valve.
How do you unblock Airstones?
Soak the airstone in a solution of one part household bleach to three parts fresh water (1:3) for 24 hours. Bleach has the advantage of both cleaning the stone and also disinfecting it. Soak the stone for a full 24 hours, or two days if the stone was badly clogged.
Is there a repair kit for a whisper 60 air pump?
This is a repair kit for whisper 60 air pumps. The whisper air pump is a unique dome shaped pump. The wide footprint, rubber feet and suspended motor all help to eliminate sound producing vibrations. Sound dampening chambers minimize turbulence while producing a smooth, almost silent stream of air.
How hard is it to replace the Whisper 100?
The replacement kit for the whisper 100 is pretty easy to install, although there is a circular felt pad included that I had a little difficulty figuring out where it goes, as there was no visible felt pad to be replaced.
How hard is it to rebuild an air pump?
Fortunately, if you chose to use the Tetra dome style air pumps, there are these excellent kits Tetra sells for rebuilding their pumps. The rebuilding process is not complicated. If you can tell which end of a small phillips/cross point screwdriver fits your hand then you can probably handle this task easily in a few minutes.
How do I replace the air hose on my pump?
Simply pull out the old one installed in the bottom of the pump housing and press in the new one that came in the kit. Reassemble the top & bottom housing halves, attach the air hoses and plug the power back in.
